[Bf-docboard-svn] bf-manual: [9261] branches/blender-3.2-release/blender_docs/manual/modeling: Curve: Improve NURBS knot generation modes

[Aaron Carlisle]

Revision: 9261
          https://developer.blender.org/rBM9261
Author:   Blendify
Date:     2022-05-09 02:02:40 +0200 (Mon, 09 May 2022)
Log Message:
-----------
Curve: Improve NURBS knot generation modes

rB0602852860dda7dfc0ea20c72e03b7f96c981f1a

Modified Paths:
--------------
    branches/blender-3.2-release/blender_docs/manual/modeling/curves/properties/active_spline.rst
    branches/blender-3.2-release/blender_docs/manual/modeling/surfaces/properties/active_spline.rst

Modified: branches/blender-3.2-release/blender_docs/manual/modeling/curves/properties/active_spline.rst
===================================================================
--- branches/blender-3.2-release/blender_docs/manual/modeling/curves/properties/active_spline.rst	2022-05-07 02:21:55 UTC (rev 9260)
+++ branches/blender-3.2-release/blender_docs/manual/modeling/curves/properties/active_spline.rst	2022-05-09 00:02:40 UTC (rev 9261)
@@ -101,10 +101,8 @@
 Bézier U
    Makes the NURBS curve act like a Bézier curve.
    The NURBS control points act like *Free* handles of Bézier curve.
-   Depending on the *Order*, 3 or 4 control points form one curve segment.
-   *Cyclic* and *Endpoint* must be disabled for this option to work.
 Endpoint U
-   Makes the curve contact the end control points. *Cyclic* must be disabled for this option to work.
+   Makes the curve contact the end control points.
 
    .. list-table::
 

Modified: branches/blender-3.2-release/blender_docs/manual/modeling/surfaces/properties/active_spline.rst
===================================================================
--- branches/blender-3.2-release/blender_docs/manual/modeling/surfaces/properties/active_spline.rst	2022-05-07 02:21:55 UTC (rev 9260)
+++ branches/blender-3.2-release/blender_docs/manual/modeling/surfaces/properties/active_spline.rst	2022-05-09 00:02:40 UTC (rev 9261)
@@ -29,11 +29,9 @@
    The control points act like *Free* handles of a Bézier curve.
    Depending on the *Order*, 3 or 4 control points form one spline segment.
    This can be set per interpolation axis.
-   *Cyclic* and *Endpoint* must be disabled for this option to work.
 Endpoint U/V
    Makes the surface contact the end control points.
    This can be set per interpolation axis.
-   *Cyclic* must be disabled for this option to work.
 
    .. figure:: /images/modeling_surfaces_properties_active-spline_endpoint.png
       :align: center