[Bf-docboard-svn] bf-manual: [8772] branches/blender-3.0-release/blender_docs/manual/modeling/geometry_nodes/curve/trim_curve.rst: Geometry Nodes: Add note about normals to the trim curve node
Hans Goudey
noreply at blender.org
Mon Dec 6 16:56:56 CET 2021
Revision: 8772
https://developer.blender.org/rBM8772
Author: HooglyBoogly
Date: 2021-12-06 16:56:56 +0100 (Mon, 06 Dec 2021)
Log Message:
-----------
Geometry Nodes: Add note about normals to the trim curve node
Modified Paths:
--------------
branches/blender-3.0-release/blender_docs/manual/modeling/geometry_nodes/curve/trim_curve.rst
Modified: branches/blender-3.0-release/blender_docs/manual/modeling/geometry_nodes/curve/trim_curve.rst
===================================================================
--- branches/blender-3.0-release/blender_docs/manual/modeling/geometry_nodes/curve/trim_curve.rst 2021-12-06 15:46:48 UTC (rev 8771)
+++ branches/blender-3.0-release/blender_docs/manual/modeling/geometry_nodes/curve/trim_curve.rst 2021-12-06 15:56:56 UTC (rev 8772)
@@ -24,8 +24,11 @@
.. note::
- If the *Start* input is larger than the *End*, then the resulting spline
- will have a single point, located at the sample location of the *Start* value.
+ Since curve :doc:`normals </modeling/geometry_nodes/input/normal>` are calculated the final curve,
+ this node may change the resulting normals when the `Minimum` twist method is used, since the `Minimum`
+ method considers the entire length of the curve to decide the final normals. In some cases the
+ :doc:`/modeling/geometry_nodes/attribute/capture_attribute` could be used to avoid this,
+ by saving the original normals to be used later.
Inputs
======
@@ -36,6 +39,11 @@
Start
The factor or length used to determine where to start each output spline.
+ .. note::
+
+ If the *Start* input is larger than the *End*, then the resulting spline
+ will have a single point, located at the sample location of the *Start* value.
+
End
The factor or length used to determine where to end each output spline.
More information about the Bf-docboard-svn
mailing list