[Bf-docboard-svn] bf-manual: [8325] trunk/blender_docs/manual/modeling/meshes/editing/mesh/knife_project.rst: Knife Project: update documentation

[Germano Cavalcante]

Revision: 8325
          https://developer.blender.org/rBM8325
Author:   mano-wii
Date:     2021-08-19 14:03:38 +0200 (Thu, 19 Aug 2021)
Log Message:
-----------
Knife Project: update documentation

Differential Revision: https://developer.blender.org/D12264

Modified Paths:
--------------
    trunk/blender_docs/manual/modeling/meshes/editing/mesh/knife_project.rst

Modified: trunk/blender_docs/manual/modeling/meshes/editing/mesh/knife_project.rst
===================================================================
--- trunk/blender_docs/manual/modeling/meshes/editing/mesh/knife_project.rst	2021-08-19 10:28:22 UTC (rev 8324)
+++ trunk/blender_docs/manual/modeling/meshes/editing/mesh/knife_project.rst	2021-08-19 12:03:38 UTC (rev 8325)
@@ -11,8 +11,9 @@
 
 Knife projection is a non-interactive tool where you can use objects to cookie-cut into
 the mesh rather than hand drawing the line.
-This works by using the outlines of other selected objects in Edit Mode to cut the mesh
-along the view axis, resulting geometry inside the cutters outline will be selected.
+This works by using the outline of selected objects that are out of edit mode to cut the
+mesh along the view axis of objects that are in edit mode,
+resulting geometry inside the cutters outline will be selected.
 Outlines can be a wireframe or boundary edges (i.e. the unconnected edges of a mesh).
 
 .. note::
@@ -23,9 +24,8 @@
    :ref:`Select Non-Manifold <bpy.ops.mesh.select_non_manifold>`
    (Wire, Boundaries) will highlight the cutting edges of mesh objects.
 
-To use Knife Project, first while in *Object Mode*, select the cutting object
-then add to that selection with :kbd:`Shift-LMB` the object to be cut.
-Now, enter *Edit Mode* and choose :menuselection:`Mesh --> Knife Project`.
+To use Knife Project, in *Edit Mode*, select the cutting object (Ctrl + Select)
+and choose :menuselection:`Mesh --> Knife Project`.
 
 .. hint::