[Bf-docboard-svn] bf-manual: [7327] trunk/blender_docs/manual/sculpt_paint/sculpting/tools: Sculpt: Enable pen pressure for Scrape/Fill Area Radius
Aaron Carlisle
noreply at blender.org
Fri Oct 30 20:42:14 CET 2020
Revision: 7327
https://developer.blender.org/rBM7327
Author: Blendify
Date: 2020-10-30 20:42:14 +0100 (Fri, 30 Oct 2020)
Log Message:
-----------
Sculpt: Enable pen pressure for Scrape/Fill Area Radius
rBc01f8bb672f3d7140f5a6df80c0279e07c4b328b
Modified Paths:
--------------
trunk/blender_docs/manual/sculpt_paint/sculpting/tools/fill.rst
trunk/blender_docs/manual/sculpt_paint/sculpting/tools/scrape.rst
Modified: trunk/blender_docs/manual/sculpt_paint/sculpting/tools/fill.rst
===================================================================
--- trunk/blender_docs/manual/sculpt_paint/sculpting/tools/fill.rst 2020-10-30 08:52:36 UTC (rev 7326)
+++ trunk/blender_docs/manual/sculpt_paint/sculpting/tools/fill.rst 2020-10-30 19:42:14 UTC (rev 7327)
@@ -18,6 +18,11 @@
Area Radius
Ratio between the brush radius and the radius that is going to be used to sample the area center.
+ Use Pressure (pressure sensitivity icon)
+ Uses stylus pressure to control how strong the effect is.
+ The gradient of the pressure can be customized using
+ the :doc:`curve widget </interface/controls/templates/curve>`.
+
Invert to Scrape
When enabled, holding :kbd:`Ctrl` while sculpting
changes the brush behavior to be the same as the *Scrape* brush.
Modified: trunk/blender_docs/manual/sculpt_paint/sculpting/tools/scrape.rst
===================================================================
--- trunk/blender_docs/manual/sculpt_paint/sculpting/tools/scrape.rst 2020-10-30 08:52:36 UTC (rev 7326)
+++ trunk/blender_docs/manual/sculpt_paint/sculpting/tools/scrape.rst 2020-10-30 19:42:14 UTC (rev 7327)
@@ -18,6 +18,11 @@
Area Radius
Ratio between the brush radius and the radius that is going to be used to sample the area center.
+ Use Pressure (pressure sensitivity icon)
+ Uses stylus pressure to control how strong the effect is.
+ The gradient of the pressure can be customized using
+ the :doc:`curve widget </interface/controls/templates/curve>`.
+
Invert to Fill
When enabled, holding :kbd:`Ctrl` while sculpting
changes the brush behavior to be the same as the *Fill* brush.
More information about the Bf-docboard-svn
mailing list