[tuhopuu-devel] loop selection/face loop cut
kino
tuhopuu-devel@blender.org
Tue, 20 Jan 2004 17:06:11 +0100
On Tue, 20 Jan 2004 09:39:17 -0600
"Johnny Matthews" <Johnny.Matthews@greenville.edu> wrote:
>
> Kino,
>
> I hope these answers help:
>
> As far as I was told, the definition of a vertex loop, the 'loops' on
> the sides of a cube are not vertex loops. Due to the fact that the
> next edge in the 'loop' shares a face with the previous and the vertex
> only has a valance of 3. Whereas the newly created loops inside the
> loop have a valance of 4 and the next edge in the loop does not share
> a face with the previous.
>
help a little, thanks :-)
i'm not a coder, just learned how to compile
> > in face loop cut when using % value and you press CTRL
> >it work for 10% 20% etc but CTRL+SHIFT dont work
>
> Yes, the cut moves at 1%
in the build i compiled when i move i have 64.34% , 88.56% etc
and change the grid seem not have effect, not a moves at 1%
>and CTRL constrains to 10% increments,
> CTRL+SHIFT is not defined.
>
will be good to have the same as in grab scale or rotate
if possible, to better control the cut
Thanks for the reply
ciao
kino
--
OS your mind, http://kino3d.com