[Bf-docboard-svn] bf-manual: [7476] trunk/blender_docs/manual/modeling/modifiers/generate/bevel.rst: Bevel Modifier > Limit Method > Angle description is reversed from behavior

[Aaron Carlisle]

Revision: 7476
          https://developer.blender.org/rBM7476
Author:   Blendify
Date:     2020-12-10 22:07:52 +0100 (Thu, 10 Dec 2020)
Log Message:
-----------
Bevel Modifier > Limit Method > Angle description is reversed from behavior

Fixes T81945

Modified Paths:
--------------
    trunk/blender_docs/manual/modeling/modifiers/generate/bevel.rst

Modified: trunk/blender_docs/manual/modeling/modifiers/generate/bevel.rst
===================================================================
--- trunk/blender_docs/manual/modeling/modifiers/generate/bevel.rst	2020-12-10 20:31:41 UTC (rev 7475)
+++ trunk/blender_docs/manual/modeling/modifiers/generate/bevel.rst	2020-12-10 21:07:52 UTC (rev 7476)
@@ -82,7 +82,7 @@
    None
       No limit, all edges will be beveled.
    Angle
-      Only edges where the adjacent faces form an angle smaller than the defined threshold will be beveled.
+      Only bevels edges whose angle of adjacent faces plus the defined *Angle* is less than 180 degrees.
       Intended to allow you to bevel only the sharp edges of an object without affecting its smooth surfaces.
    Weight
       Use each edge's bevel weight to determine the width of the bevel.