[Bf-committers] Quicktime & autoconf

[Kester Maddock]

Try setting option AGPMode in your XF86Config-4 file.  Set it to whatever is 
configured in your bios, ie if you have agp 4x put 4 there.

This is mine:
Section "Device"
    Identifier  "Voodoo3 (generic)"
    VendorName  "Unknown"
    BoardName   "Unknown"
    Driver      "tdfx"
#    VideoRam    16384
    # Clock lines


    # Uncomment following option if you see a big white block
    # instead of the cursor!                                          
    #    Option      "sw_cursor"

    Option      "AGPMode"  "2"
    Option      "DPMS"  "on"
EndSection

You can find out what modes are supported with 
lspci -vv

Look for your card entry.
This is mine.  The important part is the Rate=x1,x2 bit.
01:00.0 VGA compatible controller: 3Dfx Interactive, Inc. Voodoo 3 (rev 01) 
(prog-if 00 [VGA])
        Subsystem: 3Dfx Interactive, Inc. Voodoo3 AGP
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- 
<TAbort- <MAbort- >SERR- <PERR+
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at d4000000 (32-bit, non-prefetchable) [size=32M]
        Region 1: Memory at d8000000 (32-bit, prefetchable) [size=32M]
        Region 2: I/O ports at c000 [size=256]
        Expansion ROM at <unassigned> [disabled] [size=64K]
        Capabilities: [54] AGP version 1.0
                Status: RQ=7 SBA+ 64bit+ FW- Rate=x1,x2
                Command: RQ=0 SBA- AGP- 64bit- FW- Rate=<none>
        Capabilities: [60] Power Management version 1
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA 
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Kester